WARNING!
Apply grease to stripped aluminum conductors before you attach them to
non-coated aluminum cable lugs. Obey the grease manufacturer’s
instructions. Aluminum-aluminum contact can cause oxidation in the
contact surfaces.
7. For each cable, attach the conductive sleeve (a) to the bare cable shield with a
cable tie. Attach the cable to the support bracket with a clamp (b).
8. For each cable, connect the positive conductor(s) to terminal ES+, and the negative
conductor(s) to terminal ES-. Connect the cable shield to the PE busbar. If you use
a 3-conductor cable, connect one conductor to the PE busbar. Use the bolts, nuts,
and washers included in the delivery, and the connection method specified in Use
Electrical installation 55
To Next Page
Loading...
