ABB ACS880-34 Series - Wiring the Option Modules

WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death,
or damage to the equipment can occur.
1.
Stop the drive and do the steps in section Electrical safety precautions (page 18) before
you start work.
2. Insert the module carefully into its position on the control unit.
3. Tighten the grounding screw torque of 0.8 N·m.
Note: The screw tightens the connections and grounds the module. It is essential for
fulfilling the EMC requirements and for proper operation of the module.
3
￭ Wiring the option modules
See the appropriate option module manual for specific installation and wiring instructions.
Electrical installation 117
11