ABB ACS880-34 Series - Table of Contents

69Attaching the drive module to the LCL filter module ..........................................
69Attaching the drive module and the LCL filter module to the cabinet base ................
69Grounding the drive module and the LCL filter module ......................................
69Installing the drive in Rittal VX25 enclosure ...................................................
70Optional input power cable connection terminals and ground busbar assembly (+H370) .
70
Drive module without full-size output cable connection terminals (option +0H371) and
IP20 shrouds (option +0B051) ...................................................................
7 Guidelines for planning the electrical installation
71Contents of this chapter ...........................................................................
71Limitation of liability ................................................................................
71Selecting the main supply disconnecting device ..............................................
71European Union ................................................................................
72North America ...................................................................................
72Other regions ...................................................................................
72Selecting the main contactor .....................................................................
72Examining the compatibility of the motor and drive ...........................................
72Protecting the motor insulation and bearings ..............................................
73Requirements table ............................................................................
75Availability of du/dt filter and common mode filter by drive type .....................
75Additional requirements for explosion-safe (EX) motors ..............................
75
Additional requirements for ABB motors of types other than M2_, M3_, M4_, HX_
and AM_ ......................................................................................
75Additional requirements for the regenerative and low harmonics drives ...........
75Additional requirements for ABB high-output and IP23 motors ......................
75Additional requirements for non-ABB high-output and IP23 motors .................
76Additional data for calculating the rise time and the peak line-to-line voltage .....
77Additional note for sine filters .............................................................
77Selecting the power cables .......................................................................
77General guidelines .............................................................................
78Typical power cable sizes .....................................................................
78Power cable types ..............................................................................
78Preferred power cable types ..............................................................
79Alternate power cable types ...............................................................
80Not allowed power cable types ...........................................................
80Additional guidelines, North America ........................................................
81Metal conduit ................................................................................
81Power cable shield .............................................................................
81Selecting the control cables ......................................................................
81Shielding .........................................................................................
82Signals in separate cables ....................................................................
82Signals that can be run in the same cable ..................................................
82Relay cable ......................................................................................
82Control panel to drive cable ...................................................................
82PC tool cable ....................................................................................
82Routing the cables .................................................................................
82General guidelines – IEC ......................................................................
83General guidelines – North America .........................................................
84
Continuous motor cable shield/conduit or enclosure for equipment on the motor
cable ..............................................................................................
84Separate control cable ducts .................................................................
Table of contents 7