Required parts
Drive module standard parts
• Drive module and LCL filter module
• Top guide plate
• Fastening brackets (2 pcs)
• Grounding busbar
• Pedestal guide plates (2 pcs)
• Telescopic extraction and insertion ramp
• Fastening screws in a plastic bag
• External control unit
Drive module options
DescriptionQty (pcs)Option code
Full power cabling panels1+H381
Rittal parts and alternative ABB parts
DescriptionQty (pcs)Rittal part code
Enclosure frame: Frame, rear door, roof plate, plinth.1VX 8806.000
Side panels for the cabinet1VX 8106.245
Spacers for roof plate. Alternative ABB roof (3AUA0000125203
[IP20], AUA0000114968 [IP42]), see Air outlet kits (page 172).
1SZ/DK 7967.000
(one set = four pieces) +
additional spacers
Punched section without mounting flange, for 800 mm horizontal1VX 8617.140
(one set = four pieces)
Air filter 323 mm × 323 mm. Remove the filter mat according to
the manufacturer’s instructions.
Alternative ABB air filters (3AUA0000117002 [IP20],
3AUA0000117007 [IP42]), see Air inlet kits (page 170).
4 /
2
SK 3243.200 /
ABB 3AUA0000117002 (IP20)
ABB 3AUA0000117007 (IP42)
Customer-made parts (not ABB or Rittal products)
See Air baffles for option +H381 in 800 mm wide Rittal VX25 en-
closure (page 207)
4Air baffles
See Bottom plate (page 205)
1Cabinet bottom plate
Required tools
• Set of screw drivers (Torx and Pozidriv)
• Set of metric magnetic-end hexagon sockets
• Torque wrench with a 500 mm (20 in) or 2 × 250 mm (2 × 10 in) long extension bar
136 Installation example with full cabling panels (option +H381)
To Next Page
Loading...
