For instructions, seeTaskStep
Step-by-step drawings for an installation example
of standard drive configuration in Rittal VX25
800 mm wide enclosure (page 241)
Attach the drive module and LCL filter module to
the cabinet
3
Connect the power cables and clear plastic
shrouds to the drive module.
4
Connecting the power cables and installing the
shrouds (page 133)
Connect the power supply cable to the LCL filter
cooling fan.
Connecting the power cables (page 98)
Attaching the external control unit (page 106)
Install the external control unit5
Connecting the control cables to the terminals of
the external control unit (page 109)
Connect the control cables6
The component manufacturer’s instructionsInstall the remaining parts, for example, cabinet
doors, side plates, etc.
7
Installing the drive module and LCL filter module into a
cabinet
See Step-by-step drawings for an installation example of standard drive configuration in
Rittal VX25 800 mm wide enclosure (page 241) and ACS880-34 quick installation guide
(3AXD500000212453 [English]).
• Attach the plinth to the floor.
• Attach the cabinet frame to the plinth.
• Make the bottom plate with 360-degree grounding entries for power cables.
• Attach the bottom plate to the cabinet.
• Attach the punched section to the back of the cabinet frame.
• Attach the mounting brackets to the punched section.
• Install the pedestal to the LCL filter module.
• Install the cooling fan to the LCL filter module.
• Attach the LCL filter module pedestal guide plate to the cabinet bottom plate.
• Attach the telescopic insertion ramp to the pedestal guide plate.
• To prevent the LCL filter module from falling, attach its lifting lugs with chains to the
cabinet frame.
Installation example of the standard drive module configuration 131
To Next Page
Loading...
