Required parts
Drive module standard parts
• Drive module
• Fastening brackets (2 pcs)
• Pedestal guide plates (2 pcs)
• Telescopic extraction and insertion ramp
• Fastening screws and insulators in a plastic bag
• External control unit
Rittal parts / Alternative ABB parts
DescriptionQty (pcs)Rittal part code
Enclosure without bottom plates and side panels. Includes supports
for installing air baffles.
18806.000
Spacers for roof plates / ABB roof17967.000
(one set = four pieces)
Punched section with mounting flange, inner mounting level for
800 mm horizontal
18100.743
Air filter. Remove the filter mats.4Contact ABB for the suitable filter
Alternative ABB parts for Rittal parts
See section Air inlet kits (page 170)
2ABB air inlet kit 800 mm
3AUA0000117005 (IP20)
3AUA0000117009 (IP42)
See section Air outlet kits (page 172)
2ABB air outlet kit 800 mm
3AUA0000125203 (IP20 )
3AUA0000114968 (IP42)
Customer-made parts (not ABB or Rittal products)
See section Air baffles (page 206)
4Air baffles
See section Bottom plate (page 205)
1Bottom plate
Required tools
• Set of screw drivers (Torx and Pozidriv)
• Set of metric magnetic-end hexagon sockets
• Torque wrench
• Step drill bit for drilling the holes in the clear plastic shroud for input power cables
Overall flowchart of the installation process
For instructions, seeTaskStep
Installing the drive module and LCL filter module
into a cabinet (page 131)
Install the Rittal parts, drive bottom guide plate
and loose drive options in the drive module cu-
bicle
1
The component manufacturer’s instructionsInstall the auxiliary components (such as mount-
ing plates, air baffles, switches, busbars etc.)
2
Preventing the recirculation of hot air (page 56)
130 Installation example of the standard drive module configuration
To Next Page
Loading...
