ABB COMMANDER C355 - Page 100

98
5.10 Level E – Calibration
Note. This page enables fine tuning of the inputs to eliminate system errors.
E.00...E.04
Level E – Calibration
Note. To select this frame from anywhere in this page, press the
key for a few seconds.
Analog Input 1 Offset Calibration
Analog Input 1 Value in Engineering Units
Offset [in engineering Units]
If the
and keys are not operated for three seconds the display
reverts to the offset value only.
Analog Input 1 Span Calibration
Analog Input 1 Value in Engineering Units
Span Adjustment
[0.750 to 1.250]
If the
and keys are not operated for three seconds the display
reverts to the span value only.
Analog Input 2 Offset Calibration
Analog Input 2 Value in Engineering Units
Offset [In engineering Units]
If the
and keys are not operated for three seconds the display
reverts to the offset value only.
Analog Input 2 Span Calibration
Analog Input 2 Value in Engineering Units
Span Adjustment
[0.750 to 1.250]
If the
and keys are not operated for three seconds the display
reverts to the offset value only.
Continued…
…5 CONFIGURATION MODE
CAL
LEVE
E.00
0.0
OFF.2
E.03
0.0
SPn.1
E.02
0.0
OFF.1
E.01
1.0
SPn.2
E.04
0.0
100.3
0.0
100.3
0.0
100.3
0.0
100.3