…A2.2 Auto/Manual Station (Templates 3 and 4)
The Auto/manual Station provides a backup for a Master controller. In normal operation the COMMANDER 350’s current output follows the master
controller’s output value. A fault in the master system can be identified either by detecting a low signal on the master output
(template 3) or via a digital signal
(template 4). When a fault is detected the COMMANDER 350 selects manual mode with its output either set to the last valid maste
r output value or to a
configured output value – see Section 4.6/ Control Configuration/ Configured Output 1. When the master signal is restored or th
e digital input returns to its
normal state the COMMANDER 350 switches back to auto mode (i.e. COMMANDER 350 output = master output).
The auto/manual station can be used in series or in parallel with the master output signal – see Fig. A1. Parallel operation is
achieved by using relay 1 in
the COMMANDER 350 to energize an external relay (with suitable changeover contacts for switching low level signals) which selec
ts the output to be routed
to the actuator.
To Next Page
Loading...
