EasyManuals Logo

ABB i-bus KNX AC/S 1.x.1 Series User Manual

ABB i-bus KNX AC/S 1.x.1 Series
488 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #153 background imageLoading...
Page #153 background image
ABB i-bus
®
KNX
Parameters
AC/S 1.x.1 | 2CDC508198D0211 Rev. A 153
Send value to KNX by a change of
Options:
0…1…670760 °C
(Value range dependent on the data point type selected)
This parameter changes the send behavior. The value is only sent on the KNX bus if the new value differs
from the last value sent by the difference set. The value "0" means that this function is not active and any
value change is sent on the bus. This function affects only the output on the KNX bus. The last value is
always output on the ASM output socket.
Send cyclically values to KNX
Options:
No (checkbox cleared)
Yes (checkbox selected)
This parameter specifies whether the value is to be sent cyclically on the KNX bus.
• No (checkbox cleared): The value is only sent on the KNX bus after a change.
• Yes (checkbox selected): The value is sent on the KNX bus after every change and cyclically. The
cycle time is set in the Send cyclically values to KNX every parameter below and is restarted each
time on sending after a change.
Selection of Yes option:
Dependent parameter(s)
Send cyclically values to KNX every
Options:
00:10:00…01:00:00…23:59:00 [hh:mm:ss]

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ABB i-bus KNX AC/S 1.x.1 Series and is the answer not in the manual?

ABB i-bus KNX AC/S 1.x.1 Series Specifications

General IconGeneral
BrandABB
Modeli-bus KNX AC/S 1.x.1 Series
CategoryController
LanguageEnglish

Related product manuals