ABB i-bus KNX AC/S 1.x.1 Series - Page 171

ABB i-bus
®
KNX
Parameters
AC/S 1.x.1 | 2CDC508198D0211 Rev. A 171
Send cyclically values to KNX
Options:
No (checkbox cleared)
Yes (checkbox selected)
This parameter specifies whether the value is to be sent cyclically on the KNX bus.
• No (checkbox cleared): The value is only sent on the KNX bus after a change.
• Yes (checkbox selected): The value is sent on the KNX bus after every change and cyclically.
The cycle time is set in the Send cyclically values to KNX every parameter below and is
restarted each time on sending after a change.
Selection of Yes option:
Dependent parameter(s)
Send cyclically values to KNX every
Options:
00:10:00…01:00:00…23:59:00 [hh:mm:ss]
Selection of Input or Input + output option:
Dependent parameter(s)
Read value at startup
Options:
No (checkbox cleared)
Yes (checkbox selected)
• No (checkbox cleared): The value is only sent on the KNX bus after a change.
• Yes (checkbox selected): The value is sent on the KNX bus after every change and cyclically.
The cycle time is set in the Send cyclically values to KNX every parameter below and is
restarted each time on sending after a change.