ABB i-bus KNX AC/S 1.x.1 Series - Page 282

ABB i-bus
®
KNX
Parameters
282 2CDC508198D0211 Rev. A | AC/S 1.x.1
Object name
Object type
Unit
COV send
condition
Heating distribution circuit: Pump A operating status (Off/On)
Binary value
-
-
The module has this BACnet output object if the Yes option is selected for the Pump display operating status parameter.
Outputs the operating status (Off/On) provided by the pump. On pumps with their own control, this operating status can differ
from the operating status of the heating distribution circuit controller.
Signal value: 0 = Inactive
1 = Active
Heating distribution circuit: Pump A relay status Binary value - -
Outputs the status of the pump from the heating distribution circuit controller.
Signal value:
0 = Off
1 = On
Heating distribution circuit: Pump A fault
Binary value
-
-
The module has this BACnet output object if the Yes option is selected for the Pump display pump fault status parameter.
Outputs the fault status provided by the pump.
Signal value:
0 = Inactive
1 = Active
Heating distribution circuit: Pump A repair switch status
Binary value
-
-
The module has this BACnet output object if the Yes option is selected for the Display pump repair switch status parameter.
Outputs the contact position provided by the pump repair switch.
Signal value:
0 = Inactive
1 = Active