ABB i-bus KNX AC/S 1.x.1 Series User Manual

ABB i-bus
®
KNX
Parameters
AC/S 1.x.1 | 2CDC508198D0211 Rev. A 293
Heating curve chart
The heating curve for the ASM is shown graphically in this section. The chart shows, on the one hand, the
static heating curve based on the ASM settings and, on the other hand, the current values for the
Economy mode and Room involvement functions.
Custom heating curve chart
If the supply setpoint temperature is calculated based on the weather and in the ASM settings the Custom
option is selected for the Calculation formula parameter, you can change the curve on the web user
interface by specifying the points. The points from the ASM settings parameterized are used as the initial
values.
The settings on the web user interface always apply. The parameters set in the ASM settings are
overwritten and only become active again on the reinstallation of the ASM.

ABB i-bus KNX AC/S 1.x.1 Series Specifications

General

Brand	ABB
Model	i-bus KNX AC/S 1.x.1 Series
Category	Controller
Language	English