ABB i-bus KNX AC/S 1.x.1 Series

ABB i-bus
®
KNX
Parameters
AC/S 1.x.1 | 2CDC508198D0211 Rev. A 329
Object name
Object type
Unit
COV send
condition
Heat generator: Pump fault
Binary value
-
-
The module has this BACnet output object if the Yes option is selected for the Pump display pump fault status parameter.
Outputs the fault status provided by the pump.
Signal value: 0 = Inactive
1 = Active
Heat generator: Pump repair switch status
Binary value
-
-
The module has this BACnet output object if the Yes option is selected for the Display pump repair switch status parameter.
Outputs the contact position provided by the pump repair switch.
Signal value: 0 = Inactive
1 = Active