2 Installation and commissioning
2.5.1. Lifting robot with fork lift
3HAC023082-001 Revision: E64
© Copyright 2004-2008 ABB. All rights reserved.
6. Make sure the securing screw is removed from
the fork lift pocket! It is only used for robot
model IRB 6650S.
xx0400000977
• A: securing screw
7. Secure the fork lift pocket to the robot with the
two vertical attachment screws and washers.
Note! The vertically and the horizontally
attached screws are identical, but tightened
with different torques!
xx0300000464
• A: vertical attachment screws, 2
pcs, M16x60.
• Tightening torque: 270 Nm.
Make sure the original screws are
always used (or replacements of
equivalent quality: M16, quality 12.9)!
Attachment points on the robot are
shown in the figure Attachment points
on page 61.
8.
CAUTION!
The fork lift pocket weighs 22 kg!
9. Secure the shorter fork lift pocket on the other
side of the robot with the four remaining
horizontal attachment screws.
4 pcs, M16x60.
Tightening torque: 60 Nm.
Make sure the original screws are
always used (or replacements of
equivalent quality: M16, quality 12.9)!
Attachment points on the robot are
shown in the figure Attachment points
on page 61.
Action Note/Illustration
Continued
Continues on next page
To Next Page
Loading...
