NoteAction
xx2100001040
Remove the screws.3
Remove the block from the base4
Removing the air exhaust for Clean Room robots
NoteAction
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
1
CAUTION
For robots with protection type Clean Room
Always cut the paint with a knife and grind the
paint edge when disassembling parts of the robot!
See Cut the paint or surface on the robot before
replacing parts on page 118.
2
xx2200000280
For robots with protection type Clean Room (op-
tion 3351-1)
Remove the air exhaust by unscrewing the locking
nut
3
Continues on next page
232 Product manual - IRB 920
3HAC075721-001 Revision: C
© Copyright 2022 ABB. All rights reserved.
5 Repair
5.4.1 Replacing the base
Continued
To Next Page
Loading...
