8.2 Environmental information
Introduction
ABB robots contain components in different materials. During decommissioning,
all materials should be dismantled, recycled, or reused responsibly, according to
the relevant laws and industrial standards. Robots or parts that can be reused or
upcycled helps to reduce the usage of natural resources.
Symbol
The following symbol indicates that the product must not be disposed of as common
garbage. Handle each product according to local regulations for the respective
content (see table below).
xx1800000058
Materials used in the product
The table specifies some of the materials in the product and their respective use
throughout the product.
Dispose components properly according to local regulations to prevent health or
environmental hazards.
Example applicationMaterial
Structural parts, motors, coversAluminium
Battery unitBatteries, Lithium
Cables, motorsCopper
CoverMagnesium
Brakes, motorsNeodymium
Drive units, ball screw spline unit, cablesOil, grease
Mechanical stop rubber, seals, cables, pulley protec-
tion cover, resolver cover, VK cover, and etc
Plastic/rubber
Sheet metalStainless steel
Drive units, ball screw spline unit, screws, and etcSteel
Continues on next page
986 Product manual - IRB 920
3HAC075721-001 Revision: C
© Copyright 2022 ABB. All rights reserved.
8 Decommissioning
8.2 Environmental information
To Next Page
Loading...
