20 Preparation for installation
To connect MV drives ACS580MV and ACS6080
1. Refer to the connection of ACS880 (using supported fieldbus adapter module,
Ethernet module or Panel bus).
2. These drives also provide Ethernet tool network monitoring over the embedded
Ethernet (XETH) port.
To connect PEC/LCI
AC800PEC PC tool with appropriate license
PEC3 generation control unit. Old generation control units, such as PEC 2 needs to be
upgraded to PEC3.
To connect DCS800
SDCS-COM-8 communication module.
Note: Use CH3 channel for connecting NETA-21 to the drive.
Supported fieldbus adapter modules
The NETA-21 supports below fieldbus adapter modules:
• FENA -11
• FENA -21
• FEIP-21
• FMBT-21
• FPBA-21
To Next Page
Loading...
