Network and drive connectivity configuration 33
Network and drive connectivity
configuration
Contents of this chapter
This chapter describes how to configure the customer LAN and proxy settings for
connectivity. It also gives information on how to configure ACS800 and ACS880 devices
and the data logger for DDCS devices.
WARNING! Do not monitor a drive both NETA-21 and PC-tool simultaneously.
An error message will be displayed if you try to monitor drive both NETA-21 and
PC-tool simultaneously. For more information, see sections Connected fieldbus
adapter module is also used by PC tool on page 62 and PC tool requires DDCS
CH3 but used by NETA-21 on page 62 in chapter Installation troubleshooting (optional) on
page 57.
To Next Page
Loading...
Need help?
General
