Digital services portal package installation and use 45
For any trouble shooting, see Network error codes and their resolutions on page 63. If the
problem persists, contact your local ABB representative. Take an export of the event list
(with the Export button on the toolbar) to provide more detail.
3. After installation, run parameter logging interval templates to make sure that
parameter history logging is configured automatically for all connected drives that
have available templates. To do this, go to Reports Settings tab Parameter
logging interval templates Run Templates..
The running of the templates takes a few minutes. Verify that they are completed by
viewing Home Reports Configuration events as seen below:
4. On each connected device, Parameter browser shows the highlighted icon which
indicates that some of the parameters are being logged. You can verify this, for
example, in Devices (specific device) Parameter browser (tab) and clicking to
open parameter group "01 ACTUAL SIGNALS".
To Next Page
Loading...
