ABB REG670 - Basic IED Functions; Parameter Setting Group Handling SETGRPS; Verifying the Settings

ANSI07000188 V1 EN-US
Figure 66: Test of RTC with I/O
13.16 Basic IED functions
SEMOD52026-1 v1
13.16.1 Parameter setting group handling SETGRPS
M11369-2 v4
Prepare the IED for verification of settings as outlined in section "Preparing for test" in
this chapter.
13.16.1.1 Verifying the settings
M11369-4 v4
1. Check the configuration of binary inputs that control the selection of the active
setting group.
2. Browse to the ActiveGroup menu to achieve information about the active setting
group.
Section 13 1MRK 502 073-UUS A
Testing functionality by secondary injection
284 Generator protection REG670 2.2 ANSI and Injection equipment REX060, REX061, REX062
Commissioning manual