IEC13000062 V1 EN-US
Figure 7: Select: Use the following IP address
6. Use the ping command to verify connectivity with the IED.
7. Close all open windows and start PCM600.
The PC and IED must belong to the same subnetwork for this set-up to
work.
Setting up the PC to access the IED via a network
The same method is used as for connecting to the front port.
The PC and IED must belong to the same subnetwork for this set-up to
work.
4.7 Writing an application configuration to the IED
M11734-2 v6
When writing a configuration to the IED with PCM600, the IED is automatically set in
configuration mode. When the IED is set in configuration mode, all functions are
1MRK 502 073-UUS A Section 4
Starting up
Generator protection REG670 2.2 ANSI and Injection equipment REX060, REX061, REX062 53
Commissioning manual
To Next Page
Loading...
