ABB REG670 - Default Chapter; Table of Contents

Table of contents
Section 1 Introduction..........................................................................13
This manual............................................................................................ 13
Intended audience.................................................................................. 13
Product documentation...........................................................................14
Product documentation set................................................................14
Document revision history................................................................. 15
Related documents............................................................................16
Document symbols and conventions...................................................... 16
Symbols.............................................................................................16
Document conventions...................................................................... 17
IEC 61850 edition 1 / edition 2 mapping.................................................18
Section 2 Safety information............................................................... 29
Symbols on the product.......................................................................... 29
Warnings.................................................................................................29
Caution signs.......................................................................................... 31
Note signs...............................................................................................32
Section 3 Available functions.............................................................. 33
Main protection functions........................................................................33
Back-up protection functions.................................................................. 34
Control and monitoring functions............................................................ 35
Communication.......................................................................................40
Basic IED functions.................................................................................43
Section 4 Starting up........................................................................... 45
Factory and site acceptance testing....................................................... 45
Commissioning checklist........................................................................ 45
Checking the power supply.....................................................................46
Energizing the IED..................................................................................46
Checking the IED operation...............................................................46
IED start-up sequence.......................................................................47
Energizing REX060................................................................................ 48
REX060 start up sequence................................................................48
Setting up communication between PCM600 and the IED.....................48
Writing an application configuration to the IED.......................................53
Checking CT circuits...............................................................................54
Table of contents
Generator protection REG670 2.2 ANSI and Injection equipment REX060, REX061, REX062 1
Commissioning manual