7.7 Auditing
GUID-70137BAD-6BD5-4835-964E-B6ADAE522A15 v1
During installations, calibrations and commissions the ICT generates reports for each
of the steps and collects them under the Auditing tab. See the procedures below on how
to view and delete reports as well as generate logs from reports.
1. To view the reports, go to the Auditing tab.
GUID-8348F60B-9BF5-4018-9740-0FA3371B0F9F V1 EN-US
Figure 25: Auditing tab
2. Open and view each report.
3. View reports in one of the following ways:
• In the short cut menu, right click and select View report.
• Click the View report button in the upper right corner of the auditing
screen.
• Double click a report record.
4. Delete reports in one of the following ways:
• In the short cut menu, right click and select Delete report.
• Click the Delete report button in the upper right corner of the auditing
screen.
• Select a record with the mouse cursor then press the Delete key on the
keyboard.
5. Generate logs in one of the following ways:
Section 7 1MRK 502 073-UUS A
Calibrating injection based 100% stator earth fault protection
92 Generator protection REG670 2.2 ANSI and Injection equipment REX060, REX061, REX062
Commissioning manual
To Next Page
Loading...
