IEC13000060 V1 EN-US
Figure 6: Select the TCP/IPv4 protocol and open Properties
5. Select Use the following IP address and define IP address and Subnet mask if the
front port is used and if the IP address is not set to be obtained automatically by
the IED, see
Figure 7. The IP address must be different from the IP address chosen
for the IED.
Section 4 1MRK 502 073-UUS A
Starting up
52 Generator protection REG670 2.2 ANSI and Injection equipment REX060, REX061, REX062
Commissioning manual
To Next Page
Loading...
