Commissioning
System Manual
104
Use the following steps to set the IP address:
1. Switch to the system controller.
2. Open: The network and the enabling centre.
– "Network and Internet" / "Network and enabling centre".
3. Open: "Changing the adapter settings" [1].
– The dialogue field "Network connections" is displayed.
4. Mark the network connections in the dialogue field and open them with a right click:
Properties [3].
5. Mark in dialogue field: "Internet protocol Version 4 (TCP/IPv4)" [2].
6. Open in dialogue field: Properties [3].
7. Activate in dialogue field: Use the following IP address [4].
8. Enter the desired IP address at "IP address" [5].
9. At "Subnet mask": Only enter a click [6].
– The address is located automatically.
10. Confirm and close all windows.
The device can now be called up via a Web browser.
To Next Page
Loading...
