Connection, installation / mounting
System Manual
55
5.8 Installation recommendation
Network cables must be used for the structured cabling because they are more inflexible due to
their mechanical strength than patch cables.
For the connection inside the device box it is therefore recommended to install an RJ45
universal module (0219-101-500) to the incoming network cable.
The final cabling between the RJ45 universal module and the device is then established via a
short patch flat ribbon cable.
The RJ45 universal module and the flat ribbon cable are not included in the scope of delivery.
Notice
The flat LAN cable must be suitable for a power transmission via PoE from the
transmission standard Cat5e.
Fig. 36: Universal module 0219-101-500
To Next Page
Loading...
