EasyManua.ls Logo

ABB Welcome IP - 6.5 Adding devices manually in the Smart Access Point

ABB Welcome IP
191 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Commissioning
System Manual
112
6.5 Adding devices manually in the "Smart Access Point"
Address the device via the " IP Touch 7"
1
2
Fig. 91: IP switch actuator: commissioning mode
To address the device, perform the following steps:
1. Boot up the device.
The device boots up automatically when the power supply is connected.
If the device is already booted up, briefly interrupt the power supply of the device. The
device reboots.
The LED LED [1] lights up permanent after the automatic boot up.
2. Activating the "Commissioning mode":
After the device has booted and the LED [1] lights up permanent, briefly press the
"Reset" [2] button.
The LED [1] then flashes slowly. The flashing signals that the device is in
"Commissioning mode".
If no entry is made within the next 5 minutes, the device exits the "Commissioning
mode" automatically.
3. Switch to the indoor station.

Table of Contents

Other manuals for ABB Welcome IP

Related product manuals