Commissioning
System Manual
106
Connect.
Use the following steps to connect with the PC:
1. Connecting the PC with the LAN of the "Smart Access Point".
Fig. 84: Entering the IP address of the "Smart Access Point" in a browser
2. Call up the start page of the "Smart Access Point" in a commercially available browser.
[A} There is no router with a DHCP function in the system.
– Enter the IP address 10.0.0.1.
[B] A router with a DHCP function is integrated in this system.
– Enter the IP address that was assigned by the DHCP function of the router.
Fig. 85: Error message: Unsafe connection
– A warning is apparently displayed when the "Smart Access Point" is called up. This is
normal since this is a connection to a stationary device.
3. Acknowledge the error message if it is displayed.
To Next Page
