Commissioning
System Manual
71
5. Open the "Settings" / "Device characteristics" function.
6. In the area "Device characteristics" assign the physical address of the device.
– The physical address 001-01 has already been preset in the factory settings.
– A preset address or one that has already been entered cannot be confirmed again. In
this case, change back to the main menu. The available address then remains fixed.
7. In the "Device characteristics" sector under "Device type", select between the "Outdoor
station" or "Gate station" operating mode.
– "Outdoor station" for building or floor entrances (e.g. separate building wing).
– "Gate station" for perimeter (e.g. an associated underground car park).
The outdoor station is addressed.
To Next Page
Loading...
