Abbott Prodigy 3855 - Default Settings for Programs; Appendix B: Regulatory Statements; Statement of FCC Compliance (FCC ID:PX 2001); Disposal Guidelines for Battery-Powered Devices

Table 9. Paent programmer specicaons
Operang humidity 30%–75% (noncondensing)
Operang pressure 70–106 kPa (10.2–15.4 psi)
Default Sengs for Programs
The following table shows the default values for tonic and BurstDR™ smulaon programs for this system.
Table 10. Default sengs for programs
Program Parameter Default Value for Tonic Programs Default Value for Burst Programs
Pulse width 200 µs 1000 µs
Frequency 30 Hz N/A
Burst rate frequency N/A 40 Hz
Intraburst frequency N/A 500 Hz
Amplitude 0 mA 0 mA
Polaries O O
Number of sm sets/burst pulses 1 5
Smulaon mode Connuous Connuous
Magnet use mode On/O On/O
Step size 0.1 mA 0.05 mA
Appendix B: Regulatory Statements
This secon contains regulatory statements about your product.
Statement of FCC Compliance (FCC ID:PX 2001)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC rules. These limits are designed to provide reasonable protecon against harmful
interference in a residenal installaon. This equipment generates, uses, and can radiate radiofrequency
energy and, if not installed and used in accordance with the instrucons, may cause harmful interference to
radio communicaons. However, there is no guarantee that interference will not occur in a parcular
installaon. If this equipment does cause harmful interference to radio or television recepon, which can be
determined by turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
▪ Reorient or relocate the receiving antenna.▪
▪ Increase the separaon between the equipment and receiver.▪
▪ Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.▪
▪ Consult the dealer or an experienced radio/TV technician for help.▪
Operaon is subject to the following two condions:
▪ This device may not cause harmful interference.▪
▪ This device must accept any interference received, including interference that may cause undesired▪
operaon.
Modicaons not expressly approved by the manufacturer could void the user’s authority to operate the
equipment under FCC rules.
Disposal Guidelines for Baery-Powered Devices
This device contains a baery and a label is axed to the device in accordance with European Council
direcves 2002/96/EC and 2006/66/EC. These direcves call for separate collecon and disposal of electrical
38