Real Time Triplex Stand Alone DVR
22
CHAP 2. INSTALLATION
4. Network Connection
4.1 Using Static (Public) IP Address
You can use one of Static IP addresses, Subnet Mask and Gateway provided by your ISP (Internet
Service Provider) for network connection between DVR and Net / Web Viewer. And you can connect
DVR to your multi-port Broadband Modem directly.
4.2 Using Dynamic IP Address
You can use Router with your Dynamic IP broadband modem. In this case, you should set the
configuration of Router properly for network connection between DVR and Net / Web Viewer.
Please follow the instruction in next section to configure your Router correctly.
MODEM
MODEMBROADBAND
ROUTER
BROADBAND
If your Broadband Modem does not support internal loop back (port forwarding)
function, and if you want to monitor DVR using a PC located in same Intranet,
you should use Direct IP instead of DDVRLS in the connection menu of Net
Viewer.
If your PC is located out of Intranet, you can use both DDVRLS and Direct IP
to connect to DVR even though your Broadband Modem has limited features.
You will know about DDVRLS and Direct IP in Chapter 9, Network Viewer.
To Next Page
Loading...
General