Real Time Triplex Stand Alone DVR
30
You will see the above screen when you power on the DVR system properly.
It shows that the DVR starts and succeeds in detecting HDDs as master and slave.
CHAP 3. SETUP MENU
Getting Started
First, it is important to make sure that the DVR power is off before connecting all the necessary video, monitor
and power cables to the DVR.
[ System initializing ] [ HDD detected properly ]
1. Check if HDD has no problem after HDD installation because record function may not
work well due to HDD problem.
2. Contact your local distributor and exchange with new one when you find your HDD has
a problem.
You will see information of current available hard drives and CD burner, USB memory stick as well as
firmware version, when you press Info button. To exit to normal display, press Info button again.
To Next Page
Loading...
General