38 Configuring the Wallbox eM4Single
7 After the connection has been successfully established, the
wallbox is displayed along with its serial number and the
status Connected.
J Tap Continue to protect your wallbox from unauthorised
access using a custom password.
NOTE
Updating the software version
After the connection is established and during operation, the ABL Configuration App regularly checks whether up-to-date soft-
ware is available for the wallbox. If a message to this eect appears, you must install this update before you can continue.
8 Enter your password in the Create password field, taking
into account the specified requirements, and confirm it by
entering it again in the Repeat password field.
J Tap Continue to continue configuring the wallbox.
After setting up the access password, you can now start configuring the operating mode you selected in step 5.
NOTE
Access to wallbox configuration
You can use the password you have created to access the current configuration of the wallbox at any time in order to change it:
This process is called Reboarding and is described in the section “Control Board settings and reboarding” from page40.
x Please note that the password you have created is not stored in your mobile device’s password manager or Keychain, but is
output as a QR code (login credentials) during setup.
x You can also write down the password and keep it in a safe place for reboarding.