ABL Wallbox eM4 Single Installation Manual

37Setting up communication via the ABL Configuration App
NOTE
Access to the app’s help system
You can access the app’s help system via the
button, which is displayed in the top right of this screen.
Controller wallbox
x Use the Reset to factory settings option to reset all of the wallbox’s parameters to the factory default. You can then start a
new configuration (see below).
x The Support option will redirect you to the ABL support website (see “Support via the ABL Support page” onpage45).
Extender Wallbox
x The button will take you directly to the support website (see “Support via the ABL Support page” onpage45).
4 In the next step, select the desired mode:
J Start new configuration: Tap this option to perform a
new configuration for the operating modes Controller/
Extender or Extender as standalone (see Step 5
onwards).
J Existing configuration: Tap this option to change the
parameters of a previously created configuration in the
Control Board. You can find further information starting
on page40.
5 To start a new configuration, select the desired operating
mode for your new configuration.
J Tap Controller/ Extender to set up a Controller and
associated Extender wallboxes to operate together in a
charging group and more. You can find further information
on page39.
J Tap Extender as standalone to set up an Extender
wallbox for standalone operation without a Controller and
backend connection. You can find further information on
page39.
6 You can now establish a local wireless connection between
the mobile device and the wallbox as follows:
J Tap OK to scan the serial number on the rating plate of the
wallbox with the camera.
J Alternatively, tap the Enter serial number manually
option and enter it.

ABL Wallbox eM4 Single Specifications

General

Brand	ABL
Model	Wallbox eM4 Single
Category	Automobile Accessories
Language	English