www.accuenergy.com
V: 1.00 Revised: Jan 2021
41
• IP Address: If the DHCP is congured to “Manual”, the IP address can be congured from
this page. Default is 192.168.1.254
• Subnet Mask: If the DHCP is congured to “Manual”, the Subnet Mask can be congured
from this page. Default is 255.255.255.0
• Gateway: If the DHCP is congured to Manual, the Gateway can be congured from this
web page. Default is 192.168.1.1
The status of the Ethernet 1 port will display if it is connected or disconnected.
• Ethernet 2 DHCP: By default, the Ethernet 2 port is congured to have its DHCP set to
“Auto”. If congured to “Manual” the default Manual IP address is 192.168.1.253. Users
can congure the IP address to any IP once the DHCP is congured for “Manual”, users
will also need to set the Subnet Mask and Gateway if using this method.
NOTE: The IP address of the Ethernet 2 can be found on page N12 of the NET Settings. The AcuRev 2100
meter protocol setting must be congured to AcuRev 2100 to view this from the meters NET settings.
• IP Address: By default, the IP address is congured by DHCP, this eld will be grayed out.
If the DHCP is congured to Manual, the IP address can be congured from this page.
• Subnet Mask: If the DHCP is congured to Manual, the Subnet Mask can be congured
from this page.
• Gateway: If the DHCP is congured to Manual, the Gateway can be congured from this
web page.
The status of the Ethernet 2 port will display if it is connected or disconnected.
Chapter 7: Communications
To Next Page
Loading...
Need help?
General
