MAX_Kurzanleitung_Brief_Overview_V1.03_de_en 59 / 105
19 Delivery and assembly
Check the mobile workstation for visible transport damage. In the event of damage, you must submit to the
manufacturer a detailed damage report within 3 days of receipt of the goods. We recommend keeping the
packaging so that you can use it to send back the mobile workstation in the event of a defect.
20 Warnings
20.1 General warnings
20.2 Moving
If visible damage is present, safety is no longer guaranteed! In the event of damage, do not put the
mobile workstation and connected devices into operation!
Before you open the battery module or the electronics box, switch off the mobile workstation
using the On/Off switch, disconnect the low-power charger connection cable and unplug the
battery tray connection cable. If a DC/AC converter is installed, voltages of up to 1,000 V can occur
which can cause injury or even fatality in the event of incorrect handling or operation. This may
also cause severe material damage. Touching live parts of the cart, especially on the output side of
the DC/AC converter, can cause severe or even fatal injuries.
After automatic shutdown due to overheating or overloading, the inverter may switch on again
automatically. More information on this and possible malfunctions and their causes is available in
the chapter: Information on installation parts,
DC/AC Konverter or in the enclosed manual for the DC/AC converter.
Danger of tipping or falling!
Observe the maximum weight load of the mobile workstation or individual shelves.
Do not lean your body weight onto the handle.
Never exceed the permitted total weight and load.
To Next Page
Loading...