MAX_Kurzanleitung_Brief_Overview_V1.03_de_en 84 / 105
27.5.4.3 Mode 3: Charging and operation
You can continue working with the mobile workstation while it is in charging and operation mode.
Do not switch off the MAX Li-Ions mobile workstation for charging and plug the charger connection cable into
a stationary 230 V AC shockproof socket. You will see that the charging process has begun by looking at the
front of the battery controller; the display in percent will rise slowly after plugging in..
Do not plug the charger connecting cable into the mobile workstation socket strip because this
will not charge the batteries.
The following regulations apply to charging:
Check the charging cable for visible damage before charging.
Ensure the room in which the mobile workstation is charged is adequately ventilated.
Do not smoke or use naked flames when handling batteries.
Ensure no inflammable materials or spark-generating equipment is within a radius of at
least two metres of the mobile workstation during charging.
Keep fire extinguishing equipment ready.
Do not place metal objects on top of the batteries. Do not place objects directly on top of
the batteries.
The charging cycle in Mode 3, charging and operation, depends on the connected consumers. The
battery charging time increases with the number of consumers.
Please note that the ambient temperature during charging must be at least 15°C in order to
achieve a sufficient charge state within the specified charging time.
To Next Page
Loading...