ACT ACTsmart2 Series - Programming the Door Relay Time; Programming for ACT Smart Lock; Default Actsmart2

ACTsmart2 Operating and Installation Manual Rev. 2
Copyright © 2015 Access Control Technology Ltd.
Programming the Door Relay Time:
Programming for SmartLock:
Default ACTsmart2:
Step Present Operation
1 Programming Card
2 Programming Card
3 Programming Card
4 Programming Card
Wait for 4 seconds, Buzzer sounds indicating timing... wait
required period.
5 Programming Card Buzzer stops - timer set.
Step Present Operation
1 Programming Card
2 Programming Card
3 Programming Card
4 Programming Card
5 Programming Card Buzzer sounds intermittently and the LED ashes
6 Programming Card
Input 1 = Door Contact, AUX I/O 1 = Door Alarm, AUX I/O 2 =
SmartLock. See the SmartLock Connections diagram.
Step Present Operation
1 Programming Card
2 Programming Card
3 Programming Card
4 Programming Card
5 Programming Card
Buzzer sounds intermittently and the LED ashes RED to warn
you are about to default the system
Present Card (Not Programming
Card)
Default ACTsmart2s. Note: This deletes the Programming Card.
18