30 Second Programming Guide
ACTsmart2 PIN Only (1090)
1. Enter Programming Mode.
Press
abutton followed by the programming code (default is 9999) The LED will ash
amber.
2. Add a PIN Code
Press 12, and then enter a 4-digit PIN code. Press
abutton to complete.
3. Set Desired Door Relay Active Time
Press 20, and then enter the desired number of seconds from 000-255 (three digits with
leading zeros). Press
abutton to complete. The default time is 5 seconds.
4. Change Programming code
Press 23, then enter new 4-digit programming code. Press
ato complete.
5. Exit Programming Mode
Press the
r button. The LED turns red.
Note: The ACTsmart2 may be returned to its factory default condition at any time by
entering the programming mode and pressing 80 followed by the
abutton.
For information on programming the advanced features and networking the
ACTsmart2 range, please refer to the complete programming guide.
4
To Next Page
Loading...
Need help?
General
