ACT ACTsmart2 Series User Manual

ACTsmart2 Operating and Installation Manual Rev. 2
Copyright © 2015 Access Control Technology Ltd.
30 Second Programming Guide
ACTsmart2 Pin & Prox (1080)
(For typical Standalone System)
1. Enter Programming Mode.
Press
a button followed by the programming code (default is 9999) The LED will ash
amber.
2. Add a Batch of Cards
Press 10, then present the rst card in the batch followed by the last card in the batch.
Press
a button to complete.
3. Add a PIN Code
Press 12, and then enter a 4-digit PIN code. Press
a button to complete.
(Option 40 - Card or PIN.)
4. Set Desired Door Relay Active Time
Press 20, and then enter the desired number of seconds from 000-255 (three digits with
leading zeros). Press
a button to complete. The default time is 5 seconds.
5. Change Programming code
Press 23, then enter new 4-digit programming code. Press
a to complete
6. Exit Programming Mode
Press the
r button. The LED turns red. The ACTsmart is now ready for normal use.
Note: The ACTsmart2 may be returned to its factory default condition at any time by
entering the programming mode and pressing 80 followed by the
a button.
For information on programming the advanced features and networking the
ACTsmart2 range, please refer to the complete programming guide.
3

ACT ACTsmart2 Series Specifications

General

Brand	ACT
Model	ACTsmart2 Series
Category	Controller
Language	English