30 Second Programming Guide
ACTsmart2 Prox Only (1070)
(For typical Standalone System)
1. Choose Programming Card.
Select any proximity card or fob as the programming card (it is recommended to use the
lowest numbered card in the batch). The card will only be used for programming and
cannot be used to gain access.
2. Remove tamper and LK1 from the ACTsmart2
Make sure the ACTsmart2 is not powered up and remove the unit from the mounting plate
or the surface mount collar (this opens tamper) and also remove LK1 at the back of the
unit.
3. Assign the Programming Card
Apply power to the unit and within 10 seconds present the programming card. The unit
will beep. Take the programming card away from the unit (more than 20cm). Within a fur-
ther 10 seconds replace LK1. The unit will beep.
The card is now programmed.
Replace the ACTsmart2 on the mounting plate / surface mount collar to close tamper.
4. Add a Card Batch
Present the Programming card followed by the rst card in the batch followed by the last
card
(highest numbered).
5. Store Programming Card
Put the Programming Card in a safe place in case it is required later to add or remove
cards. The ACTsmart2 is now ready for normal use.
For more information on programming the advanced features of the ACTsmart2
1070, please refer to the complete programming guide.
2
To Next Page
Loading...
Need help?
General
