Functional Description
© 2018 ACTIA I+ME GmbH │ Ref. IR:14938 30 / 92
9.4.1 Exchanging the Slide Disk
1 Switch BOP xD off via the key switch
2 Wait until a signal is given
3 System is shut down, the Power LED goes off
4 The electromagnetic lock is switched off
5 Remove the storage device from the shaft
6 Put in the new storage device
7 Insert the storage device as far as it will go (the connector snaps in)
Before using it, format the storage drive. Formatting it guarantees that old
data is deleted from the storage device and the entire capacity is available.
9.5 Storing and Transporting the Slide Disk
The BOP xD data storage complies with the automotive requirements. The integrated
hard drives are stored for shock absorption. Regardless of their robust design,
damage resulting from improper handling cannot be excluded.
ATTENTION - Material damage
The storage device may be damaged by improper han-
dling. In the worst case, this can lead to loss of the rec-
orded data.
Therefore you must protect the data storage from humidi-
ty, moisture, strong sunlight, heat, dust and hard impacts
during storage and transportation:
We recommend using a transport box by ACTIA I+ME for securely trans-
porting and storing the data storage.
If necessary, contact your responsible project manager!
To Next Page
Loading...