BOP Standard Functions
© 2018 ACTIA I+ME GmbH │ Ref. IR:14938 31 / 92
10 BOP Standard Functions
The video surveillance system BOP xD records the video and audio data from the
cameras
microphones and
peripheral devices (e.g. GPS) connected to it.
Additional data from the vehicle is recorded to a changeable slide disk.
The evaluation is done via a live image function, alarm data transfer or at a later
point in time, over the Reviewer software. The data recorded in the event of an alarm
is stored separately. The data can be automatically sent to a central reception point
via an external modem (e.g. xNet).
10.1 Switching the Recorder on with an Ignition Signal
Switching-On Prerequisites
1 Flip the key-switch on the device to “Recording”
2 Flip the break switch on the dashboard to “Recording”
To switch BOP on, the “Terminal 15/Ignition” signal must be wired as a high active
signal to the 21-pin “I/O plug” Pin 2.
A follow-up time can be set in the configuration, under [General Settings Switch-Off
Delay].
To Next Page
Loading...
