• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 3 – 19
Using The Scan Tool
3
✓ When selected data does not exist in the Scan Tool’s memory, a
message informs the user to run the function.
3.Return to Select Print Data screen.
•Press
ENTER
.
Code Lookup
Code Lookup is used to look up definitions of DTCs stored in the Scan
Tool.
✓ The Scan Tool does not require power from the vehicle to perform this
function.
✓ Code Lookup is available from both the Main Menu and OBD II
Function List.
1.Select Code Lookup.
•Use
UP
or
DOWN
arrow
key until Code Lookup is
highlighted.
•Press
ENTER
.
2.Select a Vehicle
•See Vehicle Selection for
details regarding this step
✓ This step is available only if a vehicle has not been selected since
the tool was powered up.
✓ Selecting a vehicle may provide the user with a manufacturer
definition when looking up manufacturer specific codes.
OBD II Function List
=====================
Record Data
Vehicle Information
Modules Present
Review Data
Print Data
Code Lookup
System Setup
To Next Page
Loading...
