Configuration and Activation 4-99
16. Repeat steps 2 through 12 for each additional device that
includes a sensor(s) you want to confirm.
Note: If the location supports a second monitoring point,
remember to confirm the devices assigned to that
monitoring point, as necessary.
17. If a change has been made to any sensor parameter, reactivate
the monitor. See page 4-88 for more information on
reactivating a monitor. If you didn’t change any device
parameters, there is no need to reactivate the monitor.
18. Click on the green Hangup button in the Functions section to
disconnect from the monitor.
Qstart
XML
generates a log entry of the confirmation activity,
which includes the field and monitor readings, the name of the
crew, and any associated comments, and saves it to the local
directory or network. It also generates a log entry for each
user-initiated reading taken by the monitor that includes the
sensor fired, date and time at which the measurement was
taken, current device parameters corresponding to the sensor,
and reading and associated quality. These entries are
available for viewing through the log viewer in Qstart
XML
.
To Next Page
Loading...
