ADS TRITON+ - Communication Problems

Maintenance and Troubleshooting 11-49
Communication Problems
The following tables contain general troubleshooting techniques for
wireless communications.
Note: Contact your ADS representative for further
diagnosis prior to replacing a sensor or monitor.
Problem
Monitor does not answer via wireless communication.
Possible
Causes
Signal strength to the modem may be insufficient.
Battery pack may be dead or below minimum voltage
requirement
(7.5 volts - internal).
Wireless network failure.
SIM card is not
properly provisioned.
Monitor may have lost communication with network and
cannot re
-establish communication.
Connection type may be incorrectly configured in the
monitor
.
Antenna may be defective.
Antenna may not be attached to the monitor.
Antenna may no
t be installed correctly.
Monitor may not be on the ADS VPN network.
Monitor may be defective.
Modem may be defective.
3.3
-volt fuse on regulator may have blown.
L
eading zeros are included before or within the IP
address.