11-2 ADS TRITON+ Manual
Maintaining the System Components
The TRITON+ flow monitor and sensors should receive routine on-
site inspections and remote confidence checks to maintain the
equipment in optimal working condition, minimize monitor
downtime, and prevent possible data loss.
ADS recommends performing these inspections following initial
system installation, during site visits, and on a scheduled interval
(i.e., quarterly or during battery pack replacement).
Note: The only service or maintenance activities ADS
permits within the monitor chassis are battery pack battery
PCB, regulator/modem unit, and fuse replacement.
Therefore, do not handle, alter, modify, remove, or replace
any other components inside the monitor. Such actions
will void the monitor warranty agreement and the IS
certification.
Note: All monitor maintenance should be done with the
monitor in a non-hazardous area.
Gathering Replacement Parts and Supplies
Gather the following replacement parts and supplies for performing
routine maintenance:
z Dryer tube for sensors with pressure depth capability
z Battery pack for TRITON+ monitor
z Spare combo sensors and antenna as required
z Soft bristle brush
z Paper towels
To Next Page
Loading...