3-16 ADS TRITON+ Manual
Installing (Replacing) the SIM Card
NOTE: This instruction only applies when the TRITON+
monitor will not be using the SIM card that comes pre-
installed in the monitor. This generally applies to our
international customers. All monitors shipped by ADS
contain a SIM card either in the Regulator/Modem bowl
inside the monitor or in the SIM card enclosure on the
monitor top.
The modems in the TRITON+ monitors require a SIM card for
establishing communication. This modem supports SIM cards
provisioned by many different carriers, including SIM cards
provisioned by AT&T and Verizon for public and private, static IP
address operations as well as SIM cards provisioned by other
carriers for dynamic IP address operation. Please contact ADS if
you have specific questions about your SIM card provider and
compatibility of the provider’s SIM card with the TRITON+
monitor.
The TRITON+ monitor performs wireless communications through
an internal modem that is supported by a SIM card located in the
Regulator/Modem bowl (or on older models of the 8000-FST-IM-
4WW monitors, a SIM card enclosure on top of the monitor
canister). If a SIM card not supplied by ADS is to be used, the
installed SIM card will need to be removed. The section below
refers to replacing the SIM card in the Regulator/Modem bowl.
Refer to Replacing the SIM Card in Chapter 11 for more
information on replacing the SIM card in monitors with a SIM card
enclosure on the monitor top.
To Next Page
Loading...
