ADS TRITON+ - Page 50

2-10 ADS TRITON+ Manual
x CHANNEL 1 and CHANNEL 2 Ports These ports can receive
up to two of the following sensors:
 AV|Gated sensor
 AV|Max sensor
 Long Range Depth sensor
 ParaDepth sensor
 ParaFlow sensor
 Peak Combo sensor
 Surface Combo sensor
 Ultrasonic Depth sensor
Note: The channel ports on the TRITON+ receive any
combination of two sensors, including two of the same
sensor type. However, the sensors attached to the channel
ports must accurately reflect the channel assignments for
the sensor devices in Qstart
XML
. In addition, two sensors
of the same type may not be assigned to the same
monitoring point. Refer to Connecting Sensors to the
Monitor in Chapter 3, Sensor Installation and Connection,
for more information.
x COMM+ EXT PWR (Communication and External Power)
Port This port supports one of the following: communication,
power, sensor, or sampling options at a time:
 Direct, on-site communications with the TRITON+ monitor
through the Qstart
XML
software installed on a field computer
using a USB serial interface cable
 External power from an external source through an ExPAC,
XBUS, or XIO
 Flow proportional or level-based water quality sampling
through a third-party sampler
 ADS Inclinometer sensor
x ANTENNA Port This port receives the antenna supporting
wireless communications with the TRITON+ monitor.
The connector ports are keyed to receive only the proper sensor,
antenna, or communication cables.