ADT 4-Channel - Notification; Figure 24 Webguard Setup Screen; Figure 25 Notification Callback Setup Screen

4-Channel Digital Video Recorder
29
NOTE: Selecting Use Mobile sets the recorded image resolution to Basic automatically
regardless of your Record settings.
NOTE: Selecting Use Mobile sets the WebGuard service to be enabled automatically
regardless of your WebGuard settings.
NOTE: You can access a remote DVR and monitor live video images using media players,
such as VLC Player, supporting RTSP service. Start the media player on your local PC and
enter “rtsp://ID:Password@IP address:RTSP port number/track ID=‘channel number’”, or
start Internet Explorer on your Blackberry or other mobile devices and enter “http://IP address:
Webguard port number/”.
NOTE: Some media players might play video properly depending on network conditions.
NOTE: RTSP service might not be supported, depending on the type of media player.
Highlight the WebGuard tab, and the WebGuard setup screen displays.
Notification
Highlight Notification in the Network menu and press the button. The Notification setup screen
displays.
Figure 24  WebGuard setup screen.
Highlight Use WebGuard Service and press
the
button to toggle between On and Off. See
Appendix – WebGuard for detailed descriptions
of the WebGuard service.
Highlight the box beside Port and press the
button. Set the port number used when accessing
WebGuard by using the Up and Down arrow
buttons to increase or decrease the numbers.
Figure 25  Notification Callback setup screen.
The DVR can be set up to contact a computer
running RAS (Remote Administration System)
when an event occurs.
Highlight LAN and press
the
button to toggle between On and Off.
When LAN is turned On you can change the IP
addresses.
Highlight the IP Address box that you want to
change and press the
button. Use the arrow
buttons to enter the IP address of the computer
you want contacted during an event. You can
enter up to five IP addresses.